Adjusting Gearshift Linkage
Adjusting the Linkage
| - 1. Remove retaining screws from cover in rear of center tunnel and
withdraw cover.
|
| - 2. Loosen hex bolt in shift rod clamp.
|
| - 3. Move selector shaft of internal shift lever in transmission all
the way left to stop while in neutral position.
("Right" or "Left" is in direction of travel)
- 4. With transmission in neutral, move the gearshift lever to the
right to stop.
- 5. Tighten hex bolt of clamp to 2.5 mkp (18 lbs/ft). (Insert
serrated washer under the hex nut).
- 6. Check adjustment by shifting all gears. Also check play in the
gearshift linkage.
(Gearshift level play should be the same in all gears in all directions).
|
Last modified: Mon, 24 Jan 2005
Links
|
