Reconditioning Flywheel
If necessary recondition the flywheel gradually on a lathe (according
to table below). Please pay attention to the fact that the bearing
surface of the clutch must be reconditioned by the same proportion as
the thrust surface of the flywheel.
| Measuring point | Original measure (mm) | Grade 1 | Grade 2 | Grade 3 | Tolerance |
| A | 12.3 | 11.8 | 11.5 | 11.2 | +/- 0.1 |
| B | 22.5 | - | - | - | +/- 0.2 |
| C | 39.5 | 38.8 | 38.4 | 38.0 | +/- 0.2 |
| D | 13.25 | 12.95 | 12.75 | 12.55 | +/- 0.1 |
| E | 3.15 | 3.1 | - | - | +/- 0.05 |
| r | 0.5 | 0.5 | - | - | - 0.2 |
| b | 1 deg 30' | - | - | - | - |
|
