Rubber Plugs on Timing Gear Cover
- 2. Ensure that the dowel pins are firmly seated.
- 3. Place one rubber plug on each end of the counter pressure oil
line and install in the timing gear cover so that the open end of the
upper plug faces the crankcase while the open end of the lower plug is
inside the timing gear cover (see Fig. 154).
- 4. Inspect oil seal at crankshaft pulley and replace if worn or damaged.
- 5. Use new gasket under generator carrier.
- 6. Torque retaining nuts of timing gear cover to 2 mkp (14. 5 lbs/ft).
|
