Measure Position of the Spring Plates
If you want the ride height to remain the same after this operation
and the rear geometry not to change, take some measurements as you are
disassembling the suspension so you can put it back together the same
way. I made three 'measurements':
- I spray painted the end of the spring plate to
show there it matched the banana arm.
- I measured from the bottom of the spring plate - where the lower
bolt is attached to the banana arm - to the floor.
- I pulled the spring plate off the torsion bar leaving the inside
splines attached to the car. Then I put a piece of tape on the outside
end and marked a vertical line on the tape.
|
