Remove and Install Rocker Arm Carrier
Removal
| - 1. Remove rocker box cover.
- 2. Remove the 7 hex nuts (SW 13) from the . rocker arm shafts.
|
| - 3. Withdraw rocker arm shafts with rocker arms, springs, washers and
spacers.
- 4. Remove the three rocker arm carrier retaining bolts (SW 15 mm)
and withdraw carrier.
|
Installation
Installation is accomplished in reversed order of the above by noting
the following points:
| - 1. Inspect retaining bolts for defects. Coat threads and base of
bolt heads with graphite oil. Use new spring washers,
- 2. Tighten retaining bolts to 5 mkp (36 lbs/ft).
|
| - 3. Tighten the 7 rocker arm shaft retaining nuts (SW 13) to 2,5 mkp
(18 Ibs/ft).
- 4. Adjust valve clearance.
Reoil shafts and rocker arms, install rocker box cover.
|
Last modified: Mon, 17 Jan 2005
Links
|
