Removing and Installing Throttle Linkage
Remove
- Remove floor mat to gain access to opening in floorboard.
- Detach throttle rod at ball joint of cross-shaft at air blower housing.
- Remove gearshift lever base retaining screw (hex head).
- Withdraw gearshift lever with base.
- Remove handbrake lever with base.
- Remove attaching clip of throttle rod through freed openings.
- Detach throttle rod from rear cross-shaft ball joint joint (beneath
transmission).
- Pulling rearward, withdraw throttle rod.
Installation
Note the following during installation: The ball joints and all moving
joints of the cross-shafts should be well lubricated. Ball joint lock
nuts must be well tightened.
|
