Heat Exchanger with Exhaust Pipe R/R
Note
Engine removed, applicable to 356B/T6 Heaters.
Removal
| - Remove engine rear shield.
- Detach clamps from holders.
- Remove exhaust muffler (12 En)
|
| - Remove nuts from front and rear flanges
- Remove securing claws from both exhaust pipe ends.
- Remove retaining bracket and sheetmetal cover from heat exchangers
- Remove lower duct shroud front and rear.
- The heat exchanger can be withdrawn after removal of the front or rear
flange front the cylinder head.
|
Installation
Installalation is accomplished in reverse order of the above by noting
the following points:
- Straighten flattened or bent pipes.
- Prior to installation, check parts for proper sealing.
- Use new gaskets.
|
