Finish Assembly

Fig. 42

• 27. Install spark plugs.
• 28. Install intake manifolds using new gaskets (clean the gasket surface).
• 29. Insert blower housing with generator.
• 30. Install cylinder shrouds.
• 31. Install fuel pump shield.
• 32. Fasten lower air ducts (Export heater).
• 33. Install cylinder end shrouds.
• 34. Attach oil lines to bypass oil filter and oil- pressure switch, check for leakage.
• 35. Fasten generator strap, spin generator shaft to ensure that blower impeller is not binding.
• 36. Install V-belt.
• 37. Connect cable to Terminal I connecting coil and distributor.
• 38. Install carburetors, throttle linkage, and fuel line.
• 39. Install oil filler.
• 40. Install air cleaners.
• 41. Connect ignition leads.
• 42. Install exhaust muffler, connecting with heat exchangers.
• 43. Fill engine oil, run engine briefly and re- check oil level, replenish if necessary.